All the brands of projector cleared Methods
Panasonic projector cleared
The Panasonic projector clear method:
press the "MENU" to find the lamp time, press "ENTER" three seconds,
"POWER OFF" appears, turn off the power to restart OK!
Hitachi (Hitachi) projector clear method.
Hitachi projector clear method: boot RESET Jian 3 seconds, the time the dialogue appears select 0 OK.
SONY projectors cleared method
RESES around OK (for most Sony models)
NEC projector clear method
The 830/840/850/440 series to appear two indicator lights, including
the LAMP light, clear method is the standby at remote control OFF Kin 20
seconds in the bottom of the remote control has a headphone jack, wired
The words can be connected to the projector's remote control input
port, so that cleared convenience.
Hitachi OEM projector clear method.
Hitachi OEM clear way: boot, press RESET Jian 3 seconds, there will be a dialogue, select 0 fine.
Mitsubishi projector cleared
The Mitsubishi projector cleared Methods: power in standby, press the left and right.
Epson projector cleared
Epson projector clear method (only applicable to the lighthouse at the
resistance) machine, the lighthouse at a small resistor (cleared with),
as long as the small pin short circuit corresponding machine click on
the line, this will tired and short circuit will fix may burn the
motherboard.
Toshiba projector cleared
Toshiba projector clear:
do not take the power to determine the input power menu, press and hold
power for 3 seconds for the 780 machine.
Philips projector cleared
Philips projector clear method: boot menu, select the lamp time bar and press the OK button on the projector for 3 seconds.
SANYO, EIKI, Canon projector clear method.
All menu LAMP words of this column, all YES
PLUS (PLUS) projector clear method.
PLUS U2-811 U2-815 U2-815C U2-1110 U2-1130 U2-X1130C U2-1150, bulb
cleared within 1100 hours menu selection time, press on the remote
control ON8 seconds. The state can not boot after 1100 hours ON25
seconds on the remote control
PLUS U3-810SFC U3-1080SFC U3-810WZC
U3-1080WZC U2-X200UC 4-161 U4-121, V-1080C V-807C V-1100C U2-850 U2-1500
U2-850W U2-1500W U5-121 U5-162 menu bulb timer is cleared
INFOCUS, ASK, Proxima, IBM projector clear method
General menu Qing, InFocus 500/530 in the boot, press menu volume down
for 3 seconds, and then open the menu to see if there is no clear, if
not you can try a few times, IBM INFOCUS OEM Reference INFOCUS.
SHARP projectors cleared method
Sharp the video (PN200/300/500/C10) bulb zero time, standby, press and hold the "volume down" Select ", after boot.
Such as Sharp 100S/00X/200/220 the projector lamp cleared method, standby, press and hold -,, AUTOSYNC three key after boot.
Note: the Sharp back out of the machine (2004 new) do not arbitrarily
cleared, cleared to zero if necessary to replace the lamp, or the lamp
will be fried in about 200 hours.
No comments:
Post a Comment