Take good care of your projector lamp
Light bulb is the main light source of the projector, it works very
complicated, and will release a lot of heat during use, and each bulb is
the high price. So, we are more of the Prevention of Cruelty to light
bulbs. First thing to note the order of the switching machine, you
should first turn the power switch, then hold the Lamp button on the
projector panel, until the green light of the projector is stable; when
the projector is turned off, you should always press Lamp button until
the projector fan stops running , and then turn off the power switch. If
not in the correct order, the projector lampmay not be a good heat dissipation, seriously will lead to unimaginable danger.
After you are finished using the projector, the user should turn off
the projector control panel software switch, the light bulbs stop
working, and then let the projector fan to continue working for some
time, so the heat generated in the work cleared, the cooling fan stops
working and then cut off power, which will also benefit on the bulb.
Then, we need to be careful not to frequent power to switch between the startup and shutdown state, the user should be maintained during the time for the heat about 5 minutes, this is due to supply part of the projector using a transformer and power switch tubes and other electronic components, these components in the process of frequent switching will produce great heat, causing the projector internal temperature is too high, causing the lamp to explode.
In addition, we also do not arbitrarily move the projector in the projection process, the inside of the bulb filament usually work in the semi-molten state, frequently moving the projector at this time is likely to damage the bulbs.
Finally, when you need to replace the lamp, we should look at the manual of the projector, ensure that the replacement of the correctness of the steps, make sure that what general types of bulbs can be compatible with the projector, be sure not to use is not compatible with the projector light bulbs, may cause the lamp working properly, or even damage.
This article original of GuangZhou Prola technology Co., ltd, if Reproduced please indicate from http://www.1projectorlamp.com/take-good-care-of-the-projector-lamp.html
Then, we need to be careful not to frequent power to switch between the startup and shutdown state, the user should be maintained during the time for the heat about 5 minutes, this is due to supply part of the projector using a transformer and power switch tubes and other electronic components, these components in the process of frequent switching will produce great heat, causing the projector internal temperature is too high, causing the lamp to explode.
In addition, we also do not arbitrarily move the projector in the projection process, the inside of the bulb filament usually work in the semi-molten state, frequently moving the projector at this time is likely to damage the bulbs.
Finally, when you need to replace the lamp, we should look at the manual of the projector, ensure that the replacement of the correctness of the steps, make sure that what general types of bulbs can be compatible with the projector, be sure not to use is not compatible with the projector light bulbs, may cause the lamp working properly, or even damage.
This article original of GuangZhou Prola technology Co., ltd, if Reproduced please indicate from http://www.1projectorlamp.com/take-good-care-of-the-projector-lamp.html
No comments:
Post a Comment